Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 306 / 517

MTS - Con
fi
guring Ethernet Site Link Chapter 8: Site Controller
Procedure 8-12 MTS - How to Configure E1 Links (Continued)
6
For up to 10 MTSs connected in the line topology (i.e. Core Router 1 -----MTS1-----MTS2---....-
----MTS10(last)) use the following commands on all MTSs execpt for the last one:
.e1config -siteLink single
.e1config -DI on
.e1config -channel 1 -portNo 1
.e1config -channel 2 -portNo 2
.e1config -channel 1 -tsPattern X1 X2 ...
.e1config -channel 2 -tsPattern Y1 Y2 ...
Timeslots con
fi
gured for each site in the line must be different.
Con
fi
gure the last MTS in the chain as follows:
.e1config -siteLink single
.e1config -DI off
.e1config -channel 1 -portNo 1
.e1config -channel 1 -tsPattern X1 X2 ...
7
If the 16th timeslot on the E1 link should be allocated for signalling/synchronization according
to service provider speci
fi
cation, type
.e1config -ts16skip on
.
8
Type
.e1config
to verify that the new E1 con
fi
guration appears correctly below Next .
9
Type
reset
to reset the Site Controller and press
Enter
.
10
Type
.e1config
to verify that the new con
fi
guration has been set to Current .
MTS - Configuring Ethernet Site Link
In order to setup Ethernet Site Link, the following parameters must be con
fi
gured for Base Station:
•
Primary WAN Interface IP Address
•
Primary WAN Interface IP Netmask
•
Primary WAN Interface Gateway
•
Primary WAN Interface VLAN ID
•
Primary WAN Interface VLAN tagging
•
Primary IP Tunnel Remote IP Address
•
Primary IP Tunnel Fragmentation Size
•
Green Color Map - Yellow Color Map
•
CIR
•
CBS
•
EIR
•
EBS
•
Primary PVC IP Address
•
Primary PVC Network Mask
•
Secondary PVC IP address
8-30
6802800U74-N September 2009
•
Secondary PVC Network Mask