MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual
Base Radio Alarms
Table 13-7
Generic Base Radio Alarms (Continued)
Alarm ID
Description
Recovery
Action
Clear Action
Notes
ALM_RX_NVM_CKSUM_FAULT
Checksum
fault for the
Receiver NVM
parameters was
detected during
initialization
- some of
the Receiver
con
fi
guration
parameters may
be corrupted.
Software
attempts to set
the parameters
to the default
values taken
from the default
region in the
NVM memory.
If the operation
of restoring
defaults is
successful the
alarm is cleared.
Otherwise the
alarm status is
unchanged.
Corrupted
con
fi
guration
parameters may cause
that BRC works
incorrectly. The
default values may
be different than the
lost parameter values.
To make sure the
parameters can be
restored manually to
the earlier backed up
values.
ALM_RX_NVM_CKSUM_FAIL
The same as ALM_RX_NVM_CKSUM_FAULT
ALM_RX_FRU_BAND_MIS-
MATCH
Band mismatch
between BRC
receivers was
detected during
initialization.
Since BRC
has only one
receiver this
alarm should be
never observed.
No recovery
action taken by
the software.
The alarm will be
cleared only after
resetting BRC.
If the alarm is
reported it means
some software error.
ALM_AMBI-
ENT_TEMP_ALM_WARN
The ambient
temperature
is above
the ambient
temperature
threshold for
the low output
power.
No recovery
action taken by
the software.
If the alarm
condition
disappears then
the alarm is
cleared.
ALM_AMBIENT_TEMP_WARN
The same as ALM_AMBIENT_TEMP_ALM_WARN
ALM_AMBI-
ENT_TEMP_ALM_FAULT
The ambient
temperature is
greater than the
allowable high
temperature
threshold or
lower than the
allowable low
temperature
threshold.
BRC is de-keyed
by the software
if the ambient
temperature is
greater than
the allowable
high temperature
threshold.
If the alarm
condition
disappears the
alarm is cleared
and BRC can be
re-keyed again.
ALM_AMBIENT_TEMP_FAULT
The same as ALM_AMBIENT_TEMP_ALM_FAULT
6802800U74-N September 2009
13-25
Содержание DIMETRA MTS 2
