Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 461 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Con
fi
guring Redundant Site Controller
Procedure 15-7 Site Controller Configuration Files (Continued)
6
Download the new con
fi
guration
fi
le to the InActive Bank (set to use as next after reset).
7
Reset the Site Controller.
8
Con
fi
rm the con
fi
guration is correct.
Remember to check the con
fi
guration of both Site Controllers.
In order for the Redundant Site Controller feature to work correctly, the Ethernet ports used
to connect the two Site Controllers need to be speci
fi
cally con
fi
gured. The correct IP adresses
for each Site Controller must be as speci
fi
ed below.
Site Controller 1 (SC1)
•
eth0: 10.0.253.1
•
eth1: 10.0.254.1
Site Controller 2 (SC2)
•
eth0: 10.0.254.2
•
eth1: 10.0.253.2
Procedure 15-8 Configure Ethernet Ports
1
Log onto Boot1 of the Site Controller during startup.
2
From the prompt, run the command
spr inet/if/eth0
.
3
From the prompt, run the command
spr inet/if/eth1
.
4
Take note of the IP addresses and the MAC addresses.
If the IP addresses are set correctly (as stated in lists prior to this procedure),
continue to
Step 8 below.
If the IP addresses are set incorrectly, they must be changed as follows in the next
step.
5
Log onto Boot1 of the Site Controller.
6802800U74-N September 2009
15-31