Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 228 / 517

Base Radio Receiver Con
fi
guration Chapter 6: Con
fi
guration and Testing
Table 6-7 Corrective Actions for Missing or Bad Base Radio Parameters
Missing or Bad
Parameter
Corrective Action
atten_default
•
For MTS 4, type
set nvm_param rx1 atten_default 0
and press
Enter
.
•
For MTS 2, type
set nvm_param rx1 atten_default 4
and press
Enter
.
•
If the parameter is missing for MTS 4, add it by typing
set
nvm_miss_param rx1 atten_default 0
and press
Enter
.
•
If the parameter is missing for MTS 2, add it by typing
set
nvm_miss_param rx1 atten_default 4
and press
Enter
.
dekey_limit
Type
set nvm_param pa dekey_limit 6
and press
Enter
.
rx_dc_inj_usl Type
set nvm_param rx1 rx_dc_inj_usl 1.5
and press
Enter
.
rx_dc_inj_lsl Type
set nvm_param rx1 rx_dc_inj_lsl 0
and press
Enter
.
ad1_scaling6 Type
set nvm_param rx1 ad1_scaling6 28.9
and press
Enter
.
rx_fru_con
fi
g Type
set nvm_param rx1 rx_fru_config [X]
where the values
for [X] are:
•
1 - Receiver branch 1 enabled
•
2 - Receiver branch 2 enabled
•
3 - Receiver branches 1 and 2 enabled
•
4 - Receiver branch 3 enabled
•
5 - Receiver branches 1 and 3 enabled
•
6 - Receiver branches 2 and 3 enabled
•
7 - Receiver branches 1, 2 and 3 enabled
Press
Enter
.
After the parameter(s) has been updated the following is needed for the
con
fi
guration changes to take effect:
Type
reset
, press Enter and then type y to verify the reset.
6-20
6802800U74-N September 2009