Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 266 / 517

Reinstalling the Post Filter Chapter 7: Radio Frequency Distribution System
Procedure 7-14 How to Reinstall the Post Filter
1
Fasten the Post Filter onto the bracket with screws.
2
Slide the Post Filter into the cabinet.
3
Tighten the two fastening screws at the front to secure the mounting bracket.
4
Attach the antenna and the TX and signal cables.
5
Slide on the top rear and front panels and fasten these with screws.
6
Put the front panel back on and screw this into place.
7
Put the door of the cabinet back on.
Procedure 7-15 How to Update the Mapping List with the New TrackerID
1
Log in to the Site Controller.
2
Use the following MMI command to view the mapping list:
can check_mapping
See example below:
SC> can check_mapping
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped:
JTH0500102
3
On the list, locate the unit that you have removed and that is indicated as
Units are not
present
.
4
Delete old CAN Bus unit from the CAN Bus unit mapping list. Use
can remove_mapping
<Device>
, where <Device> is the old unit name. See example below:
SC> can remove_mapping dpm 2
5
Add new CAN Bus unit to the CAN Bus unit mapping list.
The new unit Track ID is present on the replaced unit label and indicated as
Track
ID not mapped
in the list shown in step 2 .
Use
can add_mapping <Device> <TrackID>
, where <TrackID> is a TrackID of
the new unit and <Device> is the new unit name: dpm X, where X denotes a digit between 0
and 3). See example below:
SC> can add_mapping dpm 2 JTH0500102
6
View the updated mapping list using the
can check_mapping
command and check that
there are no units labelled as
Track ID not mapped
or
Units are not present
.
7-28
6802800U74-N September 2009