Motorola DIMETRA MTS 2, Инструкция по установке, настройке и базовому обслуживанию

Страница: 325 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Con
fi
guring Redundant Site Controller
Procedure 8-28 How to Configure Ethernet Ports (Continued)
6
From the prompt, run the command
spw inet/if/eth1 “dhcp:no
addr:10.0.(255–X).X mask:255.255.255.0 dev_name:tsec1 dev_unit:1
ethaddr:
yy:yy:yy:yy:yy:yy mtu:1500”
•
There is one space between the
ethaddr:
and the
yy:yy:yy:yy:yy:yy
in the command above.
•
X = 1 for SC1, and 2 for SC2
•
yy:yy:yy:yy:yy:yy = the MAC address of the interface. Note that
eth0 and eth1 have different MAC addresses.
7
Remember to check the IP settings on both SCs.
For an MTS using a single Site Controller, the Ethernet settings should be checked
using the
ifconfig -a
command from the SC application prompt. From the
output, con
fi
rm that the eth0 and eth1 ports are con
fi
gured as expected. See Procedure
below for more information on how to set SC IDs.
Procedure 8-29 How to Configure SC IDs
The SCs must have different ID values con
fi
gured. To check the SC id, follow the steps below.
1
Log onto the Site Controller Application MMI.
2
From the SC: prompt, run the command
id
.
3
An id value of either A or B is displayed.
4
Perform the same check on the second Site Controller.
5
If the IDs are the same, one of the ID values have to be changed. To do so, log onto the Site
Controller Application MMI.
It does not matter if it is the ID value of SC1 or SC2 that is changed, as long as they
do not have the same ID value.
6
From the SC: prompt, run the command
id x
where x can be either A or B. Make sure to de
fi
ne
a value different for the two SCs.
7
Reset the Site Controller.
6802800U74-N September 2009
8-49