Mitsubishi Electric MELSERVO MR-J3 A Series, Инструкция по эксплуатации

Страница: 195 / 460

6 - 2
6. DISPLAY AND OPERATION SECTIONS
6.2 Display sequence
Press the "MODE" button once to shift to the next display mode. Refer to section 6.3 and later for the
description of the corresponding display mode.
To refer to or set the gain filter parameters, extension setting parameters and I/O setting parameters, make
them valid with parameter No. PA19 (parameter write disable).
Display mode transition Initial screen Function Reference
Servo status display.
appears at power-on. (Note)
Section 6.3
Sequence display, external signal display, output
signal (DO), forced output, test operation,
software version display, VC automatic offset,
motor series ID display, motor type ID display,
motor encoder ID display, external encoder ID
display, parameter write inhibit, next deactivation
display.
Section 6.4
Current alarm display, alarm history display,
parameter error No. display, point table error No.
display.
Section 6.5
Display and setting of basic setting parameters.
Display and setting of gain filter parameters.
Display and setting of extension setting
parameters.
Status display
Diagnosis
Alarm
Basic setting
parameters
Gain/filter
parameters
Extension setting
parameters
I/O setting
parameters
button
MODE
Display and setting of I/O setting parameters.
Section 6.6
Note. When the axis name is set to the servo amplifier using MR Configurator, the axis name is displayed and the servo status is then
displayed.