Mitsubishi Electric MELSEC-L LD75D, Руководство пользователя

Страница: 778 / 818

776
STEPPING MOTOR
A motor that rotates a given angle (example: 0.15

) when 1 pulse is generated.
For that reason, a rotation proportional to the No. of pulses can be obtained. 2-phase to 5-phase stepping motors
are available. In the 3-phase type, the rotor rotates in order from A to C when a voltage is applied. Often found in
compact motors, stepping motors rotate accurately without feedback. Be careful of step out when overloaded.
STEP FUNCTION
When the operation is designed so that several positioning data Nos. are consecutively run, this function can be
used to carry out a test operation for 1 data item at a time.
STOP WITH STOPPER
This is one machine OPR method. With this method, a stopper is established at the OP, and the operation is
stopped when the machine presses against it. Motor burning would occur or the stopper would be damaged if the
machine were left in that state.
There are two methods to prevent this; a timer can be used to shut OFF the motor after a fixed time, or the motor
can be stopped by limiting sudden increase in the motor torque when the machine presses against the stopper.
STROKE
The stroke is the variation in the operation by the distance from a stopped state to the next stopped state after a
movement.
STROKE LIMIT
This is the range in which a positioning operation is possible, or the range in which the machine can be moved
without damage occurring. (Movement outside this range is possible in the manual operation.) For operations
using a worm gear, the stroke limit is determined by the length of the screw. For operations using a fixed-feed, it
is determined by the max. dimension to be cut.
The upper/lower limits are set in the parameters, but a separate limit switch should be established and an
emergency stop circuit outside the programmable controller should be created. Refer to the term "LIMIT
SWITCH".
Term Description
4) As the excitation phase is
continuously changed, the rotor
rotates in a clockwise direction.
1) First, the A phase is excited
by a pulse.
2) When the B phase is then excited,
the force works in the direction
shown by the arrows.
3) The nearest tooth to the
B phase is attracted, and the
rotation stops.
A A
C
C B
B
N S
C
C
A A
N
S
C
C
A A
N
C
C B
B B
B
A A
Machine OPR
OP
Stopper
Lower limit
0
Upper limit
Limit switch
for emergency
stop
Positioning possible in a 3m (9.84feet) range
3m (9.84feet)