Mitsubishi Electric MELSEC-L LD75D, Руководство пользователя

Страница: 450 / 818

448
(c) Positioning data setting example
The following table shows the setting examples when " current value changing" is set in the positioning data
No. 1 of axis 1.
Refer to  Page 152, Section 5.3 for information on the setting details.
(2) Changing to a new current value using the start No. (No. 9003) for a current
value changing
(a) Operation chart
The current value is changed by setting the new current value in the current value changing buffer memory
"[Cd.9] Current value changing", setting "9003" in the "[Cd.3] Positioning start No.", and turning ON the
positioning start signal.
(b) Restrictions
• The axis error "Outside new current value range" (error code: 514) will occur if the designated value is
outside the setting range when "degree" is set in "Unit setting".
• The error "Software stroke limit +" or "Software stroke limit -" (error code: 507 or 508) will occur if the
designated value is outside the software stroke limit range.
• The current value cannot be changed during stop commands and while the M code ON signal is ON.
• The M code output function is made invalid.
Setting item Setting example Setting details
Axis 1
positioning
data No. 1
[Da.1] Operation pattern
Positioning
complete
Set "Positioning complete" assuming that the next positioning data will
not be executed. ("Continuous path control" cannot be set by current
value change.)
[Da.2] Control system
Current value
changing
Set the current value changing.
[Da.3] Acceleration time No.  Setting not required. (Setting value will be ignored.)
[Da.4] Deceleration time No.

Setting not required. (Setting value will be ignored.)
[Da.5] Axis to be interpolated

Setting not required. (Setting value will be ignored.)
[Da.6]
Positioning
address/movement amount
10000.0

m
Set the address to which address change is desired. (Assuming "mm"
is set in "[Pr.1] Unit setting".)
[Da.7] Arc address  Setting not required. (Setting value will be ignored.)
[Da.8] Command speed

Setting not required. (Setting value will be ignored.)
[Da.9] Dwell time

Setting not required. (Setting value will be ignored.)
[Da.10] M code 10
Set this when other sub operation commands are issued in combination
with the No. 1 positioning data.
Positioning start signal
Md.20 Current feed value 50000 0
OFF
ON
Current value changes to the
positioning address designated by
the current value changing buffer memory.
The above chart shows an example
when the positioning address is "0".
[Y10,Y11,Y12,Y13]