Mitsubishi Electric MELSEC-L LD75D, Руководство пользователя

Страница: 143 / 818

141
CHAPTER 5 DATA USED FOR POSITIONING CONTROL
5
5.
2
List
of
P
a
ramet
e
rs
(b) 1: Stopper method 1)
1.
Start machine OPR. (Start movement at the "[Pr.46] OPR speed" in the "[Pr.44] OPR direction".)
2.
The machine begins decelerating when the near-point dog ON is detected.
3.
The machine decelerates to the "[Pr.47] Creep speed", and subsequently moves at that speed. (At
this time "[Pr.54] OPR torque limit value" is required. If the torque is not limited, the servomotor
could be damaged in step 4.)
4.
The machine contacts against the stopper at "[Pr.47] Creep speed", and then stops.
5.
When the near-point dog turns ON and the "[Pr.49] OPR dwell time" is passed, the pulse output
from the LD75 stops, and the machine OPR is completed.
(c) 2: Stopper method 2)
1.
Start machine OPR. (Start movement at the "[Pr.46] OPR speed" in the "[Pr.44] OPR direction".)
2.
The machine begins decelerating when the near-point dog ON is detected.
3.
The machine decelerates to the "[Pr.47] Creep speed", and subsequently moves at that speed. (At
this time "[Pr.54] OPR torque limit value" is required. If the torque is not limited, the servomotor
could be damaged in step 4.)
4.
The machine contacts against the stopper at "[Pr.47] Creep speed", and then stops.
5.
After stopping, the pulse output from the LD75 stops with the zero signal (signal that is output on
detection of contact with the stopper. Input externally), and the machine OPR is completed.
t
V
1.
2.
3. 4. 5.
ON
OFF Near-point dog
OPR speed Pr.46
Creep speed Pr.47
Range to forcibly stop the servomotor
rotation with the stopper.
Dwell time
counting
Dwell time up
t
V
ON
1.
2.
3. 4
5.
OFF Near-point dog
Zero signal
OPR speed Pr.46
Pr.47
Stop with stopper
Creep speed