Mitsubishi Electric MELDAS 60 Series, Руководство по параметрам

Страница: 389 / 443

8. Spindle Parameters
8.4 MDS-C1-SPM
II - 293
No. Items Details
Setting
range
Standard
setting
3390 SP190 PG3S Spindle
synchronous
Position loop
gain 3
Set the third position loop gain when high-gain
control is carried out in the spindle
synchronous mode.
When this parameter function is not used, set
to "0". 0 to 999
(1/s) 0
3391 SP191 Use not possible. 0 0
3392 SP192 Not used. Set to "0".
3393
(PR)
SP193 SPECT Synchronized
tapping
specifications
Set the synchronized tapping specifications in
bit units. 0000 to
FFFF
HEX
setting 0000
F E D C B A 9 8
zrtn ptyp od8x phos
7 6 5 4 3 2 1 0
fdir cdir pyfx rtrn fclx
bit Name Meaning when set to 0 Meaning when set to 1
0
fclx Closed loop Semi-closed loop
(Gear 1 : 1 only)
1
2
rtrn Position monitor during
ready OFF invalid Position monitor during
ready OFF valid
3
4 cdir Command polarity (+) Command polarity (–)
5
fdir Position detector
polarity (+) Position detector
polarity (–)
6
7
8
phos Normal
(no compensation) Synchronized tapping
position command
compensation
(for synchronization with
high-gain servo)
9
A
B
C
D
od8x Magnification of
excessive error width ×
8 times invalid Magnification of
excessive error width ×
8 times valid
E
ptyp Position control switch
type: After zero point
return Position control switch
type: After deceleration
stop
F
zrtn Zero point return
direction: CCW Zero point return
direction: CW