Mitsubishi Electric MELDAS 60 Series, Руководство по параметрам

Страница: 204 / 443

6. Axis Specifications Parameters
6.4 Axis Specifications Parameters 2
II - 108
# Items Details Setting range (unit)
2076 index_x Index table
indexing
axis
Specify the index table indexing axis.
0: Normal axis
1: Index table indexing axis
Note: This parameter is valid only for the NC axis. The
parameter is invalid if specified for the PLC axis.
0/1
2077 G0inps G0
in-position
width When an in-position check is performed for G0, this
parameter is valid.
(Comparison of SV024 and this parameter, the
parameter that the in-position width is wider is applied.)
When 0 is set, this parameter is invalid.
(Applicable only to SV024)
0 to 32767 (
µ
m)
M64 specifies a 0.5
µ
m unit.
2078 G1inps G1
in-position
width When an in-position check is performed for G1, this
parameter is valid.
(Comparison of SV024 and this parameter, the
parameter that the in-position width is wider is applied.)
When 0 is set, this parameter is invalid.
(Applicable only to SV024)
0 to 32767 (
µ
m)
M64 specifies a 0.5
µ
m unit.
2079 chcomp Chopping
compensa-
tion
coefficient
Set the coefficient applied on the compensation amount
for the insufficient amount caused by servo delay
during chopping. 0 to 10
(standard value: 8)
2080 chwid Bottom
dead center
position
width Set the tolerance between the commanded stroke and
actual stroke.
During chopping, if the (command width - maximum
stroke of top/bottom dead center position /2) is within
this tolerance, compensation will be applied. Micron:
0 to 10000 (
µ
m)
Sub-micron:
0 to 10000
(0.1
µ
m)
2081 chclsp Maximum
chopping
speed Set the chopping axis clamp speed applied during
chopping. Micron:
0 to 60000
(mm/min)
Sub-micron:
0 to 60000
(0.1 mm)/min
2082 a_rstax Restart
position
return order
Designate the order for automatically returning to the
restart position.
0: Do not return.
When 0 is designated for all axes, all of the axes
will return simultaneously.
0 to 6