Installation Preparations
MyPower S6600 Series Routing Switch Installation Manual
4
copyright
©
2015 Maipu All rights reserved.
�
When installing or replacing the components of the switch, especially
installing or replacing the components with the circuit board (such as
board), we should wear anti-static wrists.
�
When holding the circuit board, please hold the edge of the circuit board and
do not touch the components or printed circuit.
�
For the security, please check the resistance of the anti-static wrists. The
resistance between the body and the ground should be 1-10 megohms.
The using steps of the anti-static wrist are as follows:
Step 1:
Put the hands into the anti-static wrist.
Step 2:
Tighten the fastener and confirm that the piece metal on the anti-static wrist is
well contacted with the skin.
Step 3:
Insert the anti-static wrists into the anti-static wrist socket, or clip the alligator
clip to the grounding pole of the chassis.
Step 4:
Confirm that the anti-static wrist well-grounded.
The using method of the anti-static wrist is as shown in the following figure.
F
F
F
F
I G U R E
I G U R E
I G U R E
I G U R E
2
2
2
2
1
1
1
1 U
U
U
U
S I N G
S I N G
S I N G
S I N G M E T H O D
M E T H O D
M E T H O D
M E T H O D D I A G R A M
D I A G R A M
D I A G R A M
D I A G R A M O F
O F
O F
O F T H E
T H E
T H E
T H E A N T I
A N T I
A N T I
A N T I
----
S T A T I C
S T A T I C
S T A T I C
S T A T I C W R I S T
W R I S T
W R I S T
W R I S T
