MyPower S6600 Series Routing Switch Installation Manual
Installation Preparations
copyright
©
2015 Maipu All rights reserved.
5
dressed with the metal pipes 15m before entering the indoor. The two sides
of the metal pipe are grounded and we should install the signal mine at the
corresponding interface of the device after the cable enters the indoor.
�
If using the shielded cable, ensure that the shielded layer well contacts with
the metal shell of the device at the device interface. We should install the
signal mine at the corresponding interface of the device after the cable
enters the indoor.
�
When the outdoor cable without any protection is connected to the device, we
should install the signal mine at the corresponding port.
�
When laying the fibers, it is required that the wiring is smooth and the bundling
the neat. It is required that the internal core wire is grounded before the
outdoor fiber enters the indoor. The fiber cannot be stretched or bundled too
tightly.
E2.2
E2.2
E2.2
E2.2 Installation
Installation
Installation
Installation Method
Method
Method
Method of
of
of
of Cable
Cable
Cable
Cable Wiring
Wiring
Wiring
Wiring
Installation
Installation
Installation
Installation Method
Method
Method
Method of
of
of
of Power
Power
Power
Power Cable
Cable
Cable
Cable
One end of the power cable is connected to the device and the other end is
connected to the power strip or lightning protection bar. The excessive part is
folded to the shape of S and fixed in the chassis. Keep a distance of more than
20cm with other cables.
Installation
Installation
Installation
Installation Method
Method
Method
Method of
of
of
of Cables
Cables
Cables
Cables
The signal cables should be installed and bundled by indoor and outdoor, drawn
from the outlet holes of different chassis to the user terminal or cascading device.
Precautions
Precautions
Precautions
Precautions for
for
for
for Using
Using
Using
Using Fiber
Fiber
Fiber
Fiber
�
When using the fiber to connect the network device, first confirm whether the
type of the optical connector and the fiber type conform to the used optical
port type.
�
Before connecting the fiber, first confirm that the optical power of the
receiving end does not exceed the upper threshold of the receiving optical
power of the optical module. Otherwise, it may burn the optical module.
�
If the optical port is not connected to the optical connector, please be sure to
wear a protective cap.
�
If the optical port is not connected to the optical connector and the protective
cap is opened, maybe some invisible rays emitted from the optical port, so
