Installation Preparations
MyPower S6600 Series Routing Switch Installation Manual
2
copyright
©
2015 Maipu All rights reserved.
�
Long cable can be bound via the cable ties. Do not bind the cable to the air
outlet of the switch to prevent cable premature aging.
�
The cable is fixed near the switch and the cable between the fixed point and
the switch interface should be loose. To mark the cable, stick a label on the
cable.
F2
F2
F2
F2
Cable
Cable
Cable
Cable Binding
Binding
Binding
Binding Recommendation
Recommendation
Recommendation
Recommendation
�
The cable should be bound straightly and tidily in the cabinet. No cable winding
or bending condition is allowed. The cable binding diagram is shown as
follows:
A
A
A
A
P P E N D I X
P P E N D I X
P P E N D I X
P P E N D I X F I G U R E
F I G U R E
F I G U R E
F I G U R E
F
F
F
F
2
2
2
2 T
T
T
T
H E
H E
H E
H E C A B L E
C A B L E
C A B L E
C A B L E B I N D I N G
B I N D I N G
B I N D I N G
B I N D I N G D I A G R A M
D I A G R A M
D I A G R A M
D I A G R A M
�
The bending radius of the cable should not be less than 2 times of the cable
diameter. At the cable outlet of the connector, its bending radius should not
be less than the 5 times of the diameter.
�
The cables of different types (power cable, signal wire, and earth wire, etc.)
should be wired and bound separately and cannot be bound together. When
these cables are close to each other, laying the cable crossly.
When wiring in
parallel, the space between the power cable and the signal wire should not be
less than 30mm.
�
The cabling rack and cabling channel inside and outside the cabinet should be
smooth and has no sharp corner.
�
Bind the cable using cable ties and cut the unnecessary parts. The cut should
be smooth and neat, without sharp corner, as shown in the following figure.
The diagram of binding the cable is shown as follows:
