Maipu SM6600-04-MF, Руководство по установке

Страница: 155 / 174

MyPower S6600 Series Routing Switch Installation Manual
Installation Preparations
copyright
©
2015 Maipu All rights reserved. 3
� When assessing the ground load-bearing, please consider the requirement of
the future switch capacity expansion (for example, add board).
D1.5 D1.5 D1.5 D1.5 Space Space Space Space Requirement Requirement Requirement Requirement
To ensure that there is enough operation space for handling the chassis and
plugging and maintaining the module, it is recommended that the aisle width of
the equipment room is no less than 0.8m. If installing the switch in the cabinet,
the net height of the equipment room cannot be less than 3m.
To be convenient for cooling and maintaining the device, do not install the device
against the wall. The front and rear space of the switch should be no less than
0.7m.
D1.6
D1.6 D1.6
D1.6 Cleanliness
Cleanliness Cleanliness
Cleanliness Requirement
Requirement Requirement
Requirement
Dust is harmful for the device operation. Dust causes electrostatic absorption,
which makes the poor contact of metal connectors. Electrostatic absorption
appears especially when the temperature and humidity are lower, which affects
the device life and easily causes communication fault. The requirement for the
dust content and particle diameter in the equipment room is as shown in
appendix table D-3:
A A A A
P P E N D I X P P E N D I X P P E N D I X P P E N D I X T A B L E T A B L E T A B L E T A B L E
D D D D 3 3 3 3 D D D D
U S T U S T U S T U S T R E Q U I R E M E N T R E Q U I R E M E N T R E Q U I R E M E N T R E Q U I R E M E N T F O R F O R F O R F O R E Q U I P M E N T E Q U I P M E N T E Q U I P M E N T E Q U I P M E N T R O O M R O O M R O O M R O O M
Max. Max. Max. Max. Diameter Diameter Diameter Diameter ( ( ( (μ μ μ μm) m) m) m) 0.5 0.5 0.5 0.5 1 1 1 1 3 3 3 3 5 5 5 5
Max. density
(tablets/m
3
)
1.4×10
7
7×10
5
2.4×10
5
1.3×10
5
�
If there is no visible dust on the desk within three days, it meets the
cleanliness requirement.
Apart from dust, the equipment room has the strict requirements for salts, acids,
and sulfides contained in the air, because these harmful gases speed up the
eroding of metals and the aging of some components.
We should prevent the harmful gases, such as SO2, H2S, NO2, NH3 and Cl2,
from entering the equipment room. The specific limited values are as shown in
appendix table D-4: