Konica Minolta DRYPRO793, Руководство по установке

Страница: 61 / 202

Ch.2 Unpacking and Installation
< 57 >
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
2.4.8 Removing Protective Sheet from HPRO Unit
The procedure for removal of the 14X14 film and the mylar mat used to protect the HPRO (Heat
Processing Unit) drum from vibration or shock is detailed below.
1
Loosen 1 screw (Sems
2
M3X14) and remove
the connector cover from the inside of the main
body.
2
Disconnect HPRO drum connectors from 3
locations (CN-A, CN-B, CN3).
CN-A
CN-B
CN3
3
Remove the 3 screws (TP screws M4X8)
securing the HPRO unit slide out plate to the
main body.
4
Lifting up the 3 HPRO drum cables
disconnected in step-
2
, pull out the HPRO
slide out plate from the main body to its fullest
extent.
Make sure that the 3 disconnected cables do not come into contact with
components in the main body such as rollers: such contact may result in damage.
The screw need only be loosened to remove the connector cover.
Removing the screws entirely produces the risk of the screws being dropped inside
the main body and makes the process of replacing the cover difficult.
Be careful not to make mistakes with the locations of removed screws.
Locations should be clearly marked for identification before screws are removed.