KAESER KOMPRESSOREN SIGMA CONTROL 2, Руководство пользователя

Страница: 133 / 246

Precondition SIGMA CONTROL 2 is connected to SAM 4.0 via SIGMA NETWORK and ready for operation (see
the SAM 4.0 operating manual in the chapter “Installation”)
Network pressure pB is set as the pressure for the “SAM 4.0 manual mode".
Access level 2 is activated.
The remote control is activated (see chapter 8.2.13)
Setting the IP configuration
1. Open the 8.1.1
<Communication – Ethernet/SIGMA NETWORK – IP configuration> menu.
2. Use «Up» or «Down» to select the
IP address line.
6 . 1 b a r 0 8 : 1 5 A M 8 0 ° C
Header
8.1.1 IP configuration
Menu
IP address 169.254.100.103
active line, factory setting
Subnet mask 255.255.000.000
Gateway 169,254,100.97
DNS Server 1 169,254,100.97
DNS Server 2 169,254,100.97
Restart network ☐
3. Set the IP address for SIGMA CONTROL 2 using the following pattern:
169.254.100.(SAM 4.0 machine 102)
(for the setting see chapter 8.2.14).
Setting SAM 4.0 mode
The IP address for SAM 4.0 has been set on SIGMA CONTROL 2 at the factory:
169.254.100.100 and must not be changed. The same applies to Port 2000.
1. Open the 8.1.2.2 <Communication – Ethernet/SIGMA NETWORK – Connections – SAM 4.0>
menu.
2. Use «Up» or «Down» to select the
SAM 4.0 active: line.
6 . 1 b a r 0 8 : 1 5 A M 8 0 ° C
Header
8.1.2.2 SAM 4.0
Menu
Status Counter 0
No error
------------------------------
SAM 4.0 active: ☑
Active line
Send
IP address : 169.254.100.100
3. Press «Enter».
The
SAM 4.0 active: check box flashes.
4. Press «UP».
The check box is activated.
5. Press «Enter».
The setting is applied.
6. Press the «DOWN» key.
8 Initial Start-up
8.11 Setting the machine for master control operation
No.: 9_9450 12 E
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.0.X
123