2. Open the 8.1.2.1
<Communication – Ethernet/SIGMA NETWORK – Connections – SIGMA
CONTROL 2> menu.
3. Use «Up» or «Down» to select the
Mode line.
4. Press «Enter».
The setting mode is active.
5. Use the «Up» or «Down» key to set machine 2 to
Slave.
6. Press «Enter».
The setting is applied.
7. Use «Up» or «Down» to select the
IP address line.
8. Press «Enter».
The setting mode is active.
9. Set the IP address of the communication partner (master, see above example).
10. Press «Enter».
The setting is applied.
Result The controller of machine 2 is set as slave.
8.11.5 Configuring interconnected operation using the LOAD remote contact (e.g.
SIGMA AIR MANAGER BASIC)
3)
Overview
■ Establish the electrical connection for LOAD remote contact
■ Set the LOAD remote contact operating mode and assign the input
■ If required, set temporary pressure increase
pE.
■ Activating the «remote control» key
3)
PISTON: Applies only to Airbox
➤ Set interconnected operation as described below:
8
Initial Start-up
8.11 Setting the machine for master control operation
140
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.0.X
No.: 9_9450 12 E
