3. Press «Enter».
The currently active operating mode
Remote mode flashes.
6 . 1 b a r
0 8 : 1 5 A M
8 0 ° C
Header
5.2.3 Load control
Menu
Local mode:
pA/pB Cycle
Remote mode
: loc.-load RC
active line
------------------------------
▶1 pA/pB Clock
·········
pA/pB Cycle
4. Use «Up» or «Down» to set the
loc.-load RC input.
5. Press «Enter».
The local/LOAD remote contact operating mode is set.
Assign an input for the local/LOAD remote contact for switching the pressure control
1. Use «Up» or «Down» to select the
loc.-load RC line.
2. Press «Enter».
The
DI display flashes.
6 . 1 b a r
0 8 : 1 5 A M
8 0 ° C
Header
5.2.3 Load control
Menu
pA/pB DO
DOR1.03
☐
No input assigned
Logic :
+
·········
Load RC
DI1.06
ok ☑
Logic :
+
loc.-load RC
DI1.07
☑
Active line
3. Use «Up» or «Down» to select a new input for local/LOAD remote contact.
4. Press «Enter».
The input for local/LOAD remote contact is assigned.
8.11.6.3 Setting local operating mode pB
The
pB nominal pressure is normally set for local operation.
➤ When setting the
pB nominal pressure, bear in mind that, under certain circumstances,
more than one compressor may be operating in local mode (see section 8.5 for adjusting
the nominal pressure).
Precondition Access level 2 is activated.
1. Open the 5.2.3
<Configuration – Pressure control – Load control> menu.
2. Use «Up» or «Down» to select the
Local mode line.
8
Initial Start-up
8.11 Setting the machine for master control operation
144
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.0.X
No.: 9_9450 12 E
