KAESER KOMPRESSOREN SIGMA CONTROL 2, Руководство пользователя

Страница: 81 / 246

3. Press «Enter».
The check box
Key remote will flash.
6 . 1 b a r 0 8 : 1 5 A M 8 0 ° C
Header
8 Communication
Menu
▶1 Ethernet/SIGMA NETWORK
▶2 Com-Module
Key remote : ☐
Active line with deactivated check box
4. Press «Up» key.
The check box
Key remote is activated.
6 . 1 b a r 0 8 : 1 5 A M 8 0 ° C
Header
8 Communication
Menu
▶1 Ethernet/SIGMA NETWORK
▶2 Com-Module
Key remote : ☑
Active line with deactivated check box
5. Press «Enter».
The «Remote control» key is activated.
6. Press «Escape» repeatedly to leave this menu.
Proceed in the same manner to deactivate the «remote control» key.
7. Press «Remote control» key on the operating panel of SIGMA CONTROL 2.
Result SIGMA CONTROL 2 remote control is activated.
8.2.14 IP configuration
For the SIGMA CONTROL 2 to be connected to the network, you must set the IP configuration (for
KAESER CONNECT for example).
If you use SIGMA CONTROL 2 as the master control of two machines, you set other network
parameters in the
IP configuration menu (see chapter 8.11.4).
The network parameters for the IP configuration must be specified manually. You cannot use
DHCP for an automatic IP configuration.
Precondition Access level 2 is activated.
The network parameters are known. Request the required information from your IT department.
1. Connect SIGMA CONTROL 2 to the network using an Ethernet cable.
2. Open the 8.1.1
<Communication – Ethernet/SIGMA NETWORK – IP configuration> menu.
8 Initial Start-up
8.2 Setting the controller
No.: 9_9450 12 E
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.0.X
71