Jands HOG 1000, Руководство по эксплуатации

Страница: 97 / 126

Console Inputs
••••
91
MIDI
MIDI Receive
The console can receive:
•
MIDI note data, such as from a MIDI keyboard, another HOG or a Whole Hog II.
•
MIDI show control (MSC) messages, such as from a show control sequencer, or another console with
MSC support.
•
MIDI Timecode, such as from a Timecode converter box.
Any or all of these kinds of messages can be received simultaneously.
To turn on MIDI reception, press
MIDI In
(found in the Input Panel window).
MIDI Transmit
The HOG can transmit:
•
MIDI note data (to send to a slave backup console, for instance). Press
Notes Out
to turn on.
•
MIDI show control messages (to trigger other show control equipment). Press
MSC Out
to turn on.
MIDI Notes
To trigger the console from a piece of MIDI equipment
Select
MIDI In
from the Input Panel, and make sure that the console and the MIDI equipment agree on
which channel is being used under
Rx chan
(setting the console to channel 0 puts it in ‘omni’ mode, so
that it responds to all channels).
To trigger other MIDI equipment using the console
Select Notes Out from the Input Panel, and set the MIDI channel to the correct channel for the receiving
equipment under Tx chan .
To setup another console as a tracking backup
Slave together two consoles as follows:
1
To make sure both start from the same point, reset both
consoles and load the identical show onto both machines.
2
Open the Input Panel on both, and make sure that the two
consoles agree on which MIDI channel is being used.
3
Select
Notes Out
from the Input Panel on the master
console.
4
Select
MIDI In
on the slave console. It will now track
the master console fully.
Changing the Note messages
If your MIDI equipment does not use the same messages as the standard HOG setup, you can rearrange
which note messages get sent on which button press, fader move or wheel move.
By default, all console actions are mimicked using low MIDI note numbers and MIDI controllers. The
MIDI mapping information is held in the file “setup\MIDImap.txt” on the show disk and you can edit this
file on a PC.