Jands HOG 1000, Руководство по эксплуатации

Страница: 100 / 126

94
••••
HOG – Version 3.20
Controllers 33 to 64 are the LSB parts of controllers 1 to 32, so are unavailable.
Console button events can only map to MIDI notes, polyphonic aftertouch and program change (note that
faders are also button events as they refer to which fader was used; the actual values are sent separately).
Continuous values (like a fader position) can only be sent via a controller, pitch wheel or channel
aftertouch. In addition, coord_x & coord_y must be mapped to a 14 bit controller, ie, controller 1 to 32 or
pitchwheel.
All console numbering starts at 1 rather than 0, eg, use fader 1, not fader 0.
When several buttons are mapped to one note (eg, choose = note:7) then the velocity data of the note is
used to index the actual choose button being pressed.
Some keys cause events to occur when they are released as well as when they’re pressed - if a single key is
mapped to a note then the console will respond to either a note off or a zero velocity to release the key. If a
key that needs a release message is mapped to a non-releasable MIDI event (like program change) then a
warning will occur when the show disk is loaded.
Others
Set others:1 Time others:35
Setup others:2 Blind others:36
Slash others:3 Try cue others:37
Dec others:4 Pig others:44
Minus others:5 Next page others:45
Plus others:6 DBO others:46
Thru others:7 Release others:47
At others:8 Skip up others:48
Full others:9 Skip down others:49
Backspace others:10 Cursor up others:53
Enter others:11 Cursor down others:54
Group others:12 Cursor left others:55
Position others:13 Cursor right others:56
Colour others:14 Begin others:57
Beam others:15 End others:58
Active others:17 Page up others:59
Next others:20 Page down others:60
Copy others:21 Page left others:61
Move others:22 Page right others:62
Delete others:23 Effect others:63
Undo others:24 Menus others:65
Clear others:25 Monitor others:66
Load others:26
Update others:27 Whole Hog II Specific
Record others:28 Main stop others:50
Macro others:29 Main go others:51
Page others:30 Activate others:52
Cue others:31
List others:32
Highlight others:33
Goto others:34
For example, to map the Record key to middle C then the midimap.txt entry would be
others:28 =
note:72
.
MIDI Serial Output
Custom MIDI messages can now be output using a cue’s comment box. You can use this to trigger
equipment that cannot receive MIDI Notes or MIDI Show Control.
To use MIDI Serial Output: