Jands HOG 1000, Руководство по эксплуатации

Страница: 20 / 126

14
••••
HOG – Version 3.20
Saving and Loading Shows
To avoid any potential loss of programming, save your show periodically while programming and at the
completion of every programming session. Shows should be saved on 3.5 inch 1.4 MB HD floppy disks,
formatted for IBM, just like those used with a PC. Disks can be formatted in the
Setup-Shows
window.
IMPORTANT: Always back up your shows to floppy disk. Do so frequently while
programming and always after completing a programming session. Also, we recommend
having several sets of backup disks and alternately saving to each one.
Note: Do not save to a disk that contains files you wish to keep, as the saving process
deletes the contents of the disk prior to saving the show.
Saving shows
To save to floppy disk:
1
Press setup on the desk.
2
Insert a disk into the drive. If it hasn’t been formatted
yet, the console will do so automatically.
3
Press
Save Show
.
4
Press
Okay
.
5
When save process is finished, press
Okay
.
Loading Shows at Startup
When you start up the console, the last show in use will be in memory. If you’d like to work on a different
show, it must be loaded from floppy disk:
1
Insert the floppy disk with the show you wish to load.
2
Press Load Show on the toolbar.
3
Press
Okay
to lose current show in memory and load
new show.
4
When load process is finished, press
Okay
twice.
Loading Shows
If you wish to load another show without having to switch the console off and on again, use the Load
Shows window.
1
Insert the floppy disk with the show you wish to load.
2
Press Setup on the desk.
3
Press
Shows
.
4
Press
Load Show
.
5
Press
Okay
to lose current show in memory and load
new show.
6
When load process is finished, press
Okay
twice.
New or Clean Shows
If you wish to start the console fresh with a new show, otherwise known as a clean show, this can be
achieved in two ways;
When powering up the console.