Jands HOG 1000, Руководство по эксплуатации

Страница: 54 / 126

48
••••
HOG – Version 3.20
+10
increases the intensities of selected fixtures by 10%.
-10
decreases the intensities of selected fixtures by 10%.
Taking a Snapshot of Live Output
Pressing Active followed by ENTER , the console takes a “snapshot” of the console’s current output and
loads this into the programmer. For example, if four cues are active with their faders at various levels,
Active will combine the states of all the cues into the programmer. This can then be recorded as a cue
anywhere on the console.
To use Active :
1
Set the look you want with the Masters.
2
Press Active.
3
Press ENTER.
Conditional Snapshots
In addition, you can use Active to load a subset of the console’s output. For example, to pull into the
programmer all fixtures which are currently red, press Active , the red palette button, and then ENTER .
This syntax can be used with fixtures, groups, and palettes.
Grab parameters of a certain type for fixtures selected in the programmer by holding Active and pressing
the appropriate button: Group (for intensity), Position , Colour , or Beam .
Hold Active and move parameter wheel to grab that parameter for fixtures selected in the programmer.
Active @ 50 grabs all fixtures with intensity of at least 50%. Substitute any other number for 50.
Grabbing all parameters of a fixture
Sometimes it is handy to grab all the parameters of an active fixture to make sure that they will be recorded
in a cue. You can do this by
1
Select fixtures to grab.
2
Press Pig and Active .
Extract Values from cues into the programmer
To extract fixture settings from a cue and load them into the programmer:
1
Select the fixtures.
2
Hold PIG and press
Load
. The command line shows
Extract from
.
3
Choose the cue from which to extract the settings.
Masking commands (covered in the Groups and Palettes chapter) can be used with
Extract from
to
filter out undesired parameter types.
Removing Programming
Cancelling your latest modifications
If you change your mind about a level adjustment, press the Backspace key. The current selection and
any changes you just made will be cancelled.
Undoing individual parameters
Holding Undo while moving a parameter wheel knocks out any programming for that parameter from the
programmer.
Undoing Parameters of a Certain Type
You can knockout parameters of a certain type by holding Undo and pressing the appropriate key from
Group (for intensity), Focus, Colour, and Beam .
KnockOut
This function removes selected fixtures and their programming from the programmer: