IBM BladeCenter JS12, Руководство по диагностике и обслуживанию

Страница: 222 / 318

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
See Chapter 3, “Parts listing, Type 7998,” on page 235 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Isolation
Procedure Code
Symptom Action
FSPSP02 This procedure is for
boot failures that
terminate very early
in the boot process or
when the
management card or
the VPD data on the
management card is
not operational or is
not present.
1. Replace the management card, as described in “Removing the
management card” on page 253 and “Installing the management
card” on page 254.
2. After replacing the card and installing the blade server in the chassis
unit and before rebooting the blade server or performing other
operations, ensure that the initialization of the management card
VPD occurs by waiting for the management module to discover the
blade server. Otherwise, the system might fail to IPL.
3.
If the problem persists, replace the system board and chassis
assembly, as described in “Replacing the Tier 2 system-board and
chassis assembly” on page 274.
FSPSP03 A system operator or
user error has
occurred. Refer to the documentation for the function you were attempting to
perform.
FSPSP04 A problem has been
detected in the
service processor
firmware.
1. Verify that the operating system is running. If it is running, perform
an in-band firmware update, as described in “Updating the
firmware” on page 277.
2. If the problem persists, replace the system board and chassis
assembly, as described in “Replacing the Tier 2 system-board and
chassis assembly” on page 274.
FSPSP05
The service processor
has detected a
problem in the
platform firmware.
1. Verify that the operating system is running. If it is running, perform
an in-band firmware update, as described in “Updating the
firmware” on page 277.
2. If the problem persists, replace the system board and chassis
assembly, as described in “Replacing the Tier 2 system-board and
chassis assembly” on page 274.
FSPSP06 The service processor
reported a suspected
intermittent problem. Contact IBM Support.
FSPSP07 The time of day has
been reset to the
default value.
1. Use the
chdate
command to set the Virtual I/O Server date and time,
using one of the following syntaxes:
chdate [-year YYyy]
[-month mm]
[-day dd]
[-hour HH]
[-minute MM]
[-timezone TZ]
chdate mmddHHMM[YYyy|yy]
[-timezone TZ]
2. If the problem persists, replace the battery, as described in
“Removing the battery” on page 267 and “Installing the battery” on
page 268.
208
JS12 Type 7998: Problem Determination and Service Guide