IBM BladeCenter JS12, Руководство по диагностике и обслуживанию

Страница: 114 / 318

The virtual service processor can start a variety of operating systems. Some codes
are specific to an operating system and therefore, do not apply to all operating
systems.
Table 17 lists the progress codes that might be displayed during the power-on
self-test (POST), along with suggested actions to take if the system hangs on the
progress code. Only when you experience a hang condition should you take any of
the actions described for a progress code.
In the following progress codes, x can be any number or letter.
Table 17. C2001000 to C20082FF checkpoints
v
If the system hangs on a progress code, follow the suggested actions in the order in which they are listed in
the Action column until the problem is solved. If an action solves the problem, you can stop performing the
remaining actions.
v
See Chapter 3, “Parts listing, Type 7998,” on page 235 to determine which components are CRUs and which
components are FRUs.
Progress code Description Action
C2001000 Partition auto-startup during a platform
startup
1. Go to “Recovering the system firmware” on
page 222.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C2001010 Startup source
1.
Go to “Recovering the system firmware” on
page 222.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C2001100 Adding partition resources to the
secondary configuration
1. Go to “Recovering the system firmware” on
page 222.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C20011FF Partition resources added successfully
1. Go to “Recovering the system firmware” on
page 222.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
C2001200 Checking if startup is allowed
1. Go to “Recovering the system firmware” on
page 222.
2. Replace the system-board and chassis
assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly”
on page 274.
100
JS12 Type 7998: Problem Determination and Service Guide