IBM BladeCenter JS12, Руководство по диагностике и обслуживанию

Страница: 283 / 318

CAUTION:
When replacing the lithium battery, use only IBM Part Number 16G8095 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v
Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Perform the following procedure to install the battery.
1. Follow any special handling and installation instructions that come with the
battery.
2. Tilt the battery so that you can insert it into the socket, under the battery clip.
Make sure that the side with the positive (+) symbol is facing up.
3. As you slide it under the battery clip, press the battery down into the socket.
4. Install and close the blade server cover. See “Installing and closing the blade
server cover” on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
5.
Install the blade server into the BladeCenter unit. See “Installing the blade
server in a BladeCenter unit” on page 242.
6. Turn on the blade server and reset the system date and time through the
operating system that you installed. For additional information, see your
operating-system documentation.
7. Make sure that the boot list is correct using the management module Web
interface. See the management module documentation for more information) or
the SMS Utility. See “Using the SMS utility” on page 279 for more information.
Chapter 4. Removing and replacing blade server components
269