IBM BladeCenter JS12, Руководство по диагностике и обслуживанию

Страница: 194 / 318

Table 25. A00-FF0 through A24-xxx SRNs (continued)
SRN Description FRU/action
A24-xxx Spurious interrupts have exceeded
threshold.
1. Check the BladeCenter management-module
event log; if an error was recorded by the
system, see “POST progress codes
(checkpoints)” on page 88.
2. Replace part numbers reported by the
diagnostic program.
3. If no entry is found, replace the system-board
and chassis assembly.
ssss-102 through ssss-640 SRNs for SCSI devices
These service request numbers (SRNs) identify a SCSI device problem.
Use Table 26 to identify an SRN when you suspect a SCSI device problem. Replace
the parts in the order that the failing function codes (FFCs) are listed.
Notes:
1.
Some SRNs might have 4 digits rather than 3 digits after the dash (–).
2. The ssss before the dash (–) represents the 3 digit or 4 digit SCSI SRN.
Table 26. ssss-102 through ssss-640 SRNs
SRN FFC Description and action
ssss-102 ssss An unrecoverable media error occurred.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see “POST progress codes (checkpoints)” on page 88.
2.
Replace any parts reported by the diagnostic program.
3.
Replace the system board and chassis assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly” on page 274.
ssss-104 ssss The motor failed to restart.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see “POST progress codes (checkpoints)” on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly” on page 274.
ssss-105 ssss The drive did not become ready.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see “POST progress codes (checkpoints)” on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly” on page 274.
ssss-106 ssss The electronics card test failed.
1. Check the BladeCenter management-module event log. If an error was recorded
by the system, see “POST progress codes (checkpoints)” on page 88.
2. Replace any parts reported by the diagnostic program.
3. Replace the system board and chassis assembly, as described in “Replacing the
Tier 2 system-board and chassis assembly” on page 274.
180
JS12 Type 7998: Problem Determination and Service Guide