IBM BladeCenter JS12, Руководство по диагностике и обслуживанию

Страница: 276 / 318

To install a small-form-factor expansion card, complete the following steps:
1. Read “Safety” on page v and the “Installation guidelines” on page 239.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from a
BladeCenter unit” on page 241.
3. Open and remove the blade server cover. See “Removing the blade server
cover” on page 244.
4.
Touch the static-protective package that contains the part to any unpainted metal
surface on the BladeCenter unit or any unpainted metal surface on any other
grounded rack component; then, remove the part from its package.
5. Orient the expansion card over the system board.
6. Slide the notch in the narrow end of the card into the raised hook on the
system board; then, gently pivot the card into the expansion card connectors.
7. Install and close the blade server cover. See “Installing and closing the blade
server cover” on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
8. Install the blade server into the BladeCenter unit. See “Installing the blade
server in a BladeCenter unit” on page 242.
Expansion card
Figure 20. Installing a small-form-factor expansion card
262
JS12 Type 7998: Problem Determination and Service Guide