IBM BladeCenter JS12, Руководство по диагностике и обслуживанию

Страница: 281 / 318

1. Read “Safety” on page v and the “Installation guidelines” on page 239.
2.
Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from
a BladeCenter unit” on page 241.
3. Open and remove the blade server cover. See “Removing the blade server
cover” on page 244.
4. Remove the plastic cover for the PCI-Express connector.
5. Touch the static-protective package that contains the part to any unpainted
metal surface on the BladeCenter unit or any unpainted metal surface on any
other grounded rack component; then, remove the part from its package.
6. Install the vertical (CFFv) CFFx portion of the expansion card (the smaller
card) by gently pushing the card onto the PCI-X connector.
7.
Install the horizontal (CFFh) CFFe portion of the expansion card.
a. Slide the card into the raised hook on the system board.
b.
Gently pivot the card into the PCIe connector.
8. Install and close the blade server cover. See “Installing and closing the blade
server cover” on page 245.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade server cover before installing the
blade server.
9. Install the blade server into the BladeCenter unit. See “Installing the blade
server in a BladeCenter unit” on page 242.
10. Use the documentation that comes with the expansion card to install device
drivers and to perform any configuration that the expansion card requires.
Removing the battery
You can remove and replace the battery.
Perform the following procedure to remove the battery.
Figure 24. Removing the battery
Chapter 4. Removing and replacing blade server components
267