GI-91
DUAL, TRIPLE, POKER DC Inverter : 1. General Informationi
Multi Liberty
DC Inverter
• “AIR DIRECTION”, “SWING ” and “SWING ” are disabled when the air conditioner is
not operating.
• Never operate the air conditioner for a long time with the airflow direction set downwards in
Cooling and Dry modes, as condensate may cover the flaps and water may drip inside the room.
• When the air conditioner is turned on, the motorized louver will start moving 10 seconds later, as
soon as it gets under control of the inner electronics. When the air conditioner is stopped, the
motorized louver will automatically stop in closing position. If the motorized louver malfunctions, it is
adviced to turn off the air conditioner and cut the power for some minutes; then restore the power,
turn the Unit on again and check if the louver works properly.
• Open angle of the horizontal louver should not be set to small, as cooling, drying or heating
performance may be impaired due to too restricted airflow area.
• Room temperature humidity should be less than 80%. If the air conditioner operates beyond this
limit, the surface of indoor heat exchanger could get covered with frost: in this case, adjust the
louver to the maximum open angle and select “HIGH” fan speed.
To obtain automatic swinging of air outlet louvers rightside to leftside and vice versa, it is
necessary that Indoor Unit i operating.
Press “SWING ” button on remote controller: vertical louvers will start swinging, as it is
shown in the Figure below.
To stop automatic swinging of air outlet louvers rightside to leftside and vice versa, press again
“SWING ” button on remote controller: vertical louvers will stop to swing, and fixed stop
position of louvers themselves will be restored.
Horizontal automatic swinging (“SWING”) of louvers
“SWING”
SWING
SWING
WARNING
SWING
SWING
n
ADJUSTMENT OF HORIZONTAL AIRFLOW DIRECTION (HSFU X)
