GI-83
DUAL, TRIPLE, POKER DC Inverter : 1. General Informationi
Multi Liberty
DC Inverter
How to orient vertical airflow direction:
WARNING
a)
Customized setting (STOP):
Perform this setting while the air conditioner is
operating.
Press “DIRECTION/SWING” button several
times, till the desired angle for the louver is
reached. Each time the button is pressed, the
louver mouves by 6°.
b)
Automatic swinging (“SWING”):
Perform this setting while the air conditioner
is operating.
Ke e p t h e “ D I R E C T I O N / S W I N G ” b u t t o n
pressed for more than 2 seconds, to star t
the automatic swinging of louver; press the
button again to stop the automatic swinging.
The inner electronics automatically selects the best position for the louver, according to the Indoor
Unit’s operation mode. If you desire to change this position, please proceed in the following way.
• The “DIRECTION/SWING” button will be disabled when the air conditioner is not operating.
• Never operate the air conditioner for a long time with the airflow direction set downwards in
Cooling and Dry modes, as condensate may cover the flaps and water may drip inside the room.
• When the air conditioner is turned on, the motorized louver will start moving 10 seconds later, as
soon as it gets under control of the inner electronics. When the air conditioner is stopped, the
motorized louver will automatically stop in closing position. If the motorized louver malfunctions, it is
adviced to turn off the air conditioner and cut the power for some minutes; then restore the power,
turn the Unit on again and check if the louver works properly.
• Open angle of the horizontal louver should not be set to small, as cooling, drying or heating
performance may be impaired due to too restricted airflow area.
• Room temperature humidity should be less than 80%. If the air conditioner operates beyond this
limit, the surface of indoor heat exchanger could get covered with frost: in this case, adjust the
louver to the maximum open angle and select “HIGH” fan speed.
• When the air conditioner is connected to power (initial power), the horizontal louver may generate
a sound for about 10 secondi: this is a normal operation.
• To avoid malfunctions, never attempt to move the motorized flaps by hand, but always use the
remote controller for doing this.
ADJUST
AUTO
COOL
DRY
HEAT
HEALTH
HIGH
MED
LOW
MODE
FAN SP
EED
SWIN
G
TIMER
ON
SLEEP
ON/OFF
TIMER
OFF
AUTO
CLEAN
RESET
LOCK
SET TEMPER
ATURE(
C)
FOLLOW
ME
LED
DISPLAY
CLEAR
AIR
TURBO
“SWING”
“STOP”
1.12 DISTRIBUTION OF AIRFLOW SUPPLIED BY INDOOR UNITS
n
ADJUSTING THE VERTICAL AIRFLOW DIRECTION (HKEU X)
