GI-70
DUAL, TRIPLE, POKER DC Inverter : 1. General Informationi
Multi Liberty
DC Inverter
3
1
2
When batteries are inserted, remote control display
will show “00:00” - sideways “CLOCK” indication - with
flashing colon.
1. Press “TIME ADJUST” button ( to go on
and to go back).
Every time the button is pressed, time will be
increased by 1 minute.
2. Press “OK” button to confirm setting of current
time.
3. Press “CLOCK” button to modify current time
or repeat the setting.
IR remote controller requires 2 normal alkaline
batteries “AAA” type, 1.5V.
Remove the cover of battery case by sliding it
in the direction shown by the arrows.
Pull out old batteries and insert the new ones
by respecting the polarities marked on remote
control itself.
After replacing the batteries, it is necessary to
press “RESET” button on remote controller (see
further on).
Before closing the cover again, check if on
remote controller’s display - sideways “CLOCK”
indication - “0:00” is displayed with flashing
colon (:).
After replacing batteries, it is needed to set current
time again (see below).
Note:
Insert only 2 new batteries and of the same brand. If you foresee not to use the air conditioner for a
long time, remove the batteries: they may damage the case and the electrical contacts, as acid can leak.
The average life of a pair of new batteries is of about 6 months~1 year. Batteries have to be replaced
if the signal transmission indicator on remote controller does not light any more, or if the confirmation
sound emitted by Indoor Unit’s buzzer is no more heard.
Before starting the air conditioner, it is necessary to
set current time on remote controller, as indicated in
this paragraph.
Remote control display will show current time, also if
Indoor Unit is not operating.
First setting of current time
n
FIRST FITTING IN AND/OR REPLACEMENT OF REMOTE CONTROLLER’S BATTERIES
n
FIRST SETTING OR ADJUSTMENT OF CURRENT TIME ON REMOTE CONTROL DISPLAY
