GE Corometrics 126, Руководство по обслуживанию

Страница: 164 / 440

5-20 120 Series Maternal/Fetal Monitor Revision B
2015590-001
Setup Procedures: FSpO2 Setup Screen
%O
2
Trace
This setting enables or disables the printing of the %FSpO
2
trend on the bottom grid
of the strip chart paper.
„
On: The %FSpO
2
trend is printed as a beaded trace on the bottom (or right) grid
annotated by %FSpO
2
.
„ Off: The %FSpO
2
trend is not printed.
Figure 5-10. FSpO
2
Trend
FSpO
2
Display Area
Single versus Dual Display of SpO
2
If FSpO
2
is monitored while MSpO
2
is inactive, FSpO
2
displays in the Additional
Parameters Area. Refer to Figure 6-4 . When dual SpO
2
monitoring occurs, FSpO
2
information is displayed in the Waveform Area beneath the MSpO
2
area. Any
waveform labels (speed, lead, scale) move to the left of the FSpO
2
area. The
waveform area, which would otherwise display about 4 seconds of information, is
reduced to show approximately 2.5 seconds of waveform data. Refer to
Figure 6-5 .
FSpO
2
Status Icons
A status icon may appear above the %FSpO
2
value to provide additional
information. Usually the message area will be blank; however, the icons
representing
Sensor Unplugged
,
Sensor Lifted
, or
Searching for Fetal Pulse
can appear.
Sensor Unplugged – This icon appears whenever: the FSpO
2
sensor is
disconnected from the fetal patient module cable; when the fetal patient module
cable is disconnected from the monitor; or when an invalid FSpO
2
sensor is
connected to the fetal patient module cable.
Sensor Lifted – This icon appears whenever the sensor is not making
adequate contact at the sensor site on the fetus.
Pulse Search – This icon is displayed when the monitor is attempting to
locate the fetal pulse. During successful monitoring, the message area is blank.
)
( )