Fukuda Denshi DynaScope 7000 Series, Руководство по эксплуатации

Страница: 380 / 475

Functions that can be assigned to the Function Keys
Function Description
ECG1 Size
ECG2 Size
Switches the ECG1 (ECG2) size each time the key is pressed.
×
1/4 →
×
1/2 →
×
1 →
×
2 →
×
4 →
×
1/4
ECG1 Lead
ECG2 Lead
Switches the ECG1 (ECG2) lead each time the key is pressed.
3-electrode:
Ι
→
ΙΙ
→
ΙΙΙ
→
Ι
4-electrode:
Ι
→
ΙΙ
→
ΙΙΙ
→ aVR → aVL → aVF →
Ι
5-electrode:
Ι
→
ΙΙ
→
ΙΙΙ
→ aVR → aVL → aVF → V →
Ι
ECG Auto Size
Automatically adjusts the ECG waveform size to 10mm amplitude.
This function is effective only when the key is pressed.
BP1 to BP6 Scale
Switches the BP1 to BP6 scale each time the key is pressed.
20
→ 50 → 75 → 100 → 150 → 200 → 250 → 300 → 20 (mmHg)
4 → 8 → 12 → 16 → 20 → 24 → 32 → 40 → 4 (kPa)
PCWP
When the BP label is set to PAP, PCWP input screen will be
displayed.
NIBP Start/Stop
Starts/stops the NIBP measurement.
Pressing this key will display a message on the monitor to press the
“Check” key. When the “Check” key is pressed, the measurement will
start. To cancel the process, press the “Home” key.
Pressing the “NIBP Start/Stop” key during measurement will stop the
measurement.
Record Start/Stop
Starts/stops the manual recording. The recording duration set on the
manual recording setup menu will be applied.
Resume Resumes monitoring when the monitoring is suspended.
Freeze
Stops the waveform trace. Pressing this key again will resume the
waveform trace.
Trend Displays the trend data.
Table Displays the data in tabular format.
OCRG Displays the OCRG screen.
Recall Displays the recall data.
ST Displays the ST measurement screen.
ST Trend Displays the ST trend.
ST Table Displays the ST data in tabular format.
Cardiac Output
Displays the CO measurement screen. This key will not start the CO
measurement.
Hemodynamics Displays the hemodynamics screen.
Night Mode Turns ON/OFF the Night Mode.
Switch Display
Switches the Home Display mode in the order of
Auto
→ Standard → Zoom → Extended → Auto.
Respiration Table Displays the respiration data in tabular format.
Vigilance Table Displays the Vigilance data in tabular format
NICO Table Displays the NICO data in tabular format.
BIS Table Displays the BIS data in tabular format.
VENT (P-V) Displays the ventilator P-V loop.
VENT (F-V) Displays the ventilator F-V loop.
VENT (Numeric) Displays the ventilator numeric data.
OFF Turns OFF the key operation.
5
Check the setting.
C A U T I O N
z Do not set the same remote control bed ID to more than one monitors on
the same floor. Otherwise, it may cause to remote control more than one
monitors at the same time.
z
After the remote control setup, check that the remote control unit properly
operates.
9 － 20