Endress+Hauser SpectraSensors J22 TDLAS, Руководство по эксплуатации

Страница: 130 / 150

Operating Instructions J22 TDLAS Gas Analyzer
130 Hauser
11.6.12 ATEX/IECEx heater, E+H material number 70188857 (SS P/N 1100002271)
Materials
1.
Socket head screw, M5-0.8 x 50 (3)
2.
Lock washer (3)
3.
Flat washer (3)
4.
Heater
5.
Label, terminal block
6.
Ground cable GRN/YEL
7.
Locking terminal fork (6)
8.
Thermostat
9.
Thermal compound grease
10.
Label, terminal block
11.
Terminal block

Torque screws (item 1) to 5.1 Nm (45.1 lb-in).

Crimp terminals per manufacturer specifications with
Panduit CT-1550 or equivalent.

Apply a thin, even coat of thermal compound (item 9) 0.1 mm thick to the bottom surface of the heater block
(item 4) when installing it on the heater plate assembly

Service technicians will be required to install the input power.

Refer to the dashed lines in the wiring diagram for field technicians installation requirements and the solid lines
for the factory installed components.

Both heater and thermostat ground wires use the same terminal fork.
11.6.13 CSA heater, E+H material number 70188858 (SS P/N 1100002272)
WIRING ASSEMBLY:
(REF WIRING SCHEMATIC BELOW)
GROUND
SCREW
A 100 to 240 VAC ± 10%, 50/60 HZ, Main power
B Heater G/Y Green/yellow
C Thermostat L Line
BR Brown wire N Neutral
BL Blue wire G Ground
A
L BR
N BL
BROWN BL
G G/Y
G/Y
Wiring diagram
B
C
WIRING ASSEMBLY:
(REF WIRING SCHEMATIC BELOW)
GROUND
SCREW