multi N/C 2100S (duo, pharma)
Security
13
2.4.3
Electrical system safety instructions
Life-threatening electrical voltages occur in the device in the area of the right side
component! Contact with live components may cause death, serious injury or painful
electrical shock.
¡
The power plug must be connected to a proper power outlet to ensure that the
device meets protection class I (ground connector). The device may only be con-
nected to power sources whose nominal voltage is the same as that on the rating
plate of the equipment. Do not replace the removable power cable of the device
with a power cable that does not meet the specifications (with no protective
ground conductor). Extensions of the supply cable are not permitted!
¡
Work on the electronics may only be carried out by the customer service of Ana-
lytik Jena and specially authorized technicians.
¡
The electrical components must be checked regularly by a qualified electrician.
Any defects such as loose connections or faulty or damaged cables must be re-
paired without delay.
¡
Before opening the device, the device must be switched off via the main switch
and the power plug must be disconnected from the power outlet!
¡
The basic module and the system components may only be connected to the
mains when they are switched off.
¡
Electrical connection cables between the basic module and the system compo-
nents may only be connected or disconnected when the device is switched off.
¡
Switch off the analyzer immediately using the main switch on the rear of the
housing if there is any malfunction of the electrical components. Disconnect the
power plug from the power socket.
2.4.4
Safety instructions for the operation of compressed gas containers and compressed gas
systems
¡
The operating gases are taken from compressed gas containers or local com-
pressed gas systems. The operating gases must have the required purity.
¡
Work on compressed gas containers and systems may only be carried out by indi-
viduals with specialist knowledge and experience in compressed gas systems.
¡
Compressed air hoses and pressure reducers may only be used for the assigned
gases.
¡
Pipes, hoses, screw connections and pressure reducers for oxygen must be kept
free from grease.
¡
Check all pipes, hoses and screw connections regularly for leaks and externally
visible damage. Repair leaks and damage without delay.
¡
Shut off the gas supply to the device prior to any maintenance and repair work
on the compressed gas containers.
¡
After successful repair and maintenance of the components of the compressed
gas containers or system, the device must be checked for proper operation prior
to recommissioning.
¡
Unauthorized assembly and installation are not permitted!
2.4.5
Handling of auxiliary and operating materials
The operator is responsible for the selection of substances used in the process as well
as for their safe handling. This is particularly important for radioactive, infectious,
poisonous, corrosive, combustible, explosive and otherwise dangerous substances.
When handling hazardous substances, the locally applicable safety instructions and
instructions in the safety data sheets from the manufacturers of the auxiliary and op-
erating materials must be complied with.
