12
Installation and Service Guide: Color Controller E-85A
Introduction
Do the following to avoid damage due to electrostatic discharge:
•
Work on a grounded antistatic mat.
•
Wear an antistatic wristband, attached to the same location as the antistatic mat.
•
Before you remove an electronic component from the shipping box, touch a metal area of the printer to discharge static
from your body.
•
After you remove an electronic component from the shipping box, place it face up on a grounded antistatic surface.
•
Leave electronic components in antistatic bags until you are ready to use them.
•
Do not walk on carpet or vinyl while carrying an electronic component, unless it is in an antistatic bag.
•
If you remove an electronic component from the printer, immediately place it in an antistatic bag.
The power cable
Observe the following guidelines:
•
Only use the power cable that shipped with the E-85A or an appropriate replacement power cable. For replacement
parts, see your authorized service support center.
•
Before you open the E-85A, unplug the E-85A.
•
Keep the power cable away from foot traffic.
•
Do not place objects on the power cable.
•
Do not plug the E-85A into a 2-hole, ungrounded outlet by means of a 3-prong adapter.
•
Do not plug the E-85A into a circuit connected to heating or refrigeration equipment (including a water dispenser).
•
Do not plug the E-85A into a switchable outlet.
•
Do not pull the cable to unplug the E-85A. Instead, pull the plug.
•
Do not tamper with or disable the power cable grounding plug.
•
Do not use an extension cord.
Do not bring liquids near the E-85A
If liquid spills on the E-85A, immediately unplug the E-85A.
Do not open the power supply
For more information about the power supply, see
Do not open the hard disk drive
For more information about the hard disk drive, see
