EFI E-85A, Инструкция по установке и обслуживанию

Страница: 115 / 143

115 Installation and Service Guide: Color Controller E-85A
Troubleshooting
Startup (continued)
System does not display the
Windows Log on window
within five minutes of power
up, or does not display Fiery
Ticker within five minutes of
logging on. One of the following:
•
System was powered off and then
powered on before waiting
10 seconds
•
Improperly installed keyboard and
mouse connections
•
Missing, unmatched, incorrect, or
faulty DIMMs
•
Faulty or overheated CPU(s)
•
Faulty motherboard
1 Power off, wait 10 seconds, and then power on again.
2 If problem persists, check all cables and connections
again and reboot.
Make sure that the keyboard and mouse are installed in
the proper connectors. Power off, wait 10 seconds, and
power on again.
3 Check the DIMMs and reseat them to remove any
oxidation on the connectors (see page 69 ). Make sure
that the DIMM configurations in both socket sets are
identical (see
page 69 ).
4 If the problem persists, test the DIMMs by removing
all DIMMs except for the ones installed in A0 and E0
and reboot the system.
If the system boots to Idle, install a different DIMM in
the available slot indicated in
“Table 3: Available
DIMM slots” on page 70 and reboot the system.
Continue to install a different DIMM in the slot and
reboot the system until the system fails to reach Idle.
The last DIMM that you installed may be faulty and
should be replaced.
Note:
If the system fails to reach Idle with each DIMM
installed in the next available slot, the DIMM socket may
be faulty and you may need to replace the motherboard.
5 If the problem persists, verify CPU and CPU fan
connections, and verify that the CPU heatsinks are
securely installed (see
page 72 ).
Test the CPUs by removing the CPU installed in socket
CPU1 and rebooting.
•
If the system fails to boot up properly, the CPU in
socket CPU0 is faulty and should be replaced.
•
If the system boots up properly, the CPU in socket
CPU0 is good and the CPU that you removed from
socket CPU1 may be faulty. To test this, remove the
CPU from socket CPU0, install the other CPU in
socket CPU0, and reboot. If the system fails to boot
up properly, the CPU currently installed in socket
CPU0 is faulty and should be replaced.
6 If the problem persists, you may need to replace the
motherboard (see page 59 ).
Symptom Possible cause Suggested action