13
Installation and Service Guide: Color Controller E-85A
Introduction
Lift the E-85A carefully
The E-85A weighs approximately 22kg. At least two persons are required to move the device.
Never lift the E-85A by grasping the top panel. The top panel does not support the weight of the E-85A.
ATTENTION:
Ne jamais soulever le serveur d’impression par sa partie supérieure : celle-ci ne peut pas supporter le poids
du système.
AVVERTENZA:
Il server di stampa non deve essere mai sollevato afferrandolo dal pannello superiore, in quanto
quest’ultimo non può sostenere il peso dell’intero sistema.
WARNUNG:
Heben Sie den Druckserver nicht an der oberen Gehäuseabdeckung an. Die obere Gehäuseabdeckung ist nicht
dafür ausgelegt, das Gesamtgewicht des Systems zu tragen.
ADVERTENCIA:
No levante nunca el servidor de impresión agarrándolo por el panel superior. El panel superior no soporta
el peso del sistema.
ADVERTÊNCIA:
Nunca erga o servidor de impressão pelo painel superior. O painel superior não suporta o peso do sistema.
WAARSCHUWING:
Til de afdrukserver nooit op door het bovenpaneel vast te nemen. Het bovenpaneel kan het gewicht
van het systeem niet dragen.
Power supply cord notice
Lithium battery notice
Short circuit protection
Important:
The power supply cord is used as the main disconnect device. Ensure that the power outlet is located/
installed near the equipment and is easily accessible.
Caution:
There is a danger of explosion if the battery is replaced with an incorrect type. Replace a battery only with
the same type recommended by the manufacturer. Dispose of used batteries according to local regulations.
Warning:
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that a
fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase
conductors (all current-carrying conductors).
