59
Installation and Service Guide: Color Controller E-85A
Replacing parts
3
Connect the SW/LED cables from the Fiery QuickTouch panel to the J102 connector.
4
Connect the 10-pin power button cable from the FPIO_1 connector to the J103 connector (see
5
Reassemble the E-85A and verify its functionality (see
Graphics board
The graphics board provides the external DVI, HDMI , and VGA ports for the monitor video cable. Connect your monitor
to the appropriate port. The model and appearance of the board may vary between systems. No additional software is
required to use the monitor ports provided by the board.
To remove the graphics board
When you handle electronic components, follow electrostatic discharge precautions (see
).
1
Shut down the E-85A, remove all cables from the back, and open the E-85A (see
2
Remove the screws that secures the board’s mounting bracket to the connector panel and save them for later.
3
Gently pull the board out its connector on the motherboard and place it in an antistatic bag.
Be careful not to disturb nearby cables.
To install the graphics board
When you handle electronic components, follow electrostatic discharge precautions (see
).
1
Insert the board into the
PCIE_1
(bottom) connector on the motherboard.
The component side of the board must face down, toward the base of the chassis. The board connector is keyed to fit
only one way.
When reseating the board, be careful not to disturb any motherboard cables that are installed nearby.
2
Attach the board to the connector panel with the screws you removed earlier.
3
Reassemble the E-85A and verify its functionality.
Motherboard
The motherboard contains two CPUs. The CPUs control the image data transferred to and from the printer interface board.
The motherboard also controls hard disk drive functions and the communication between the E-85A and external devices.
1
LED cable connection
2
SW cable connection
LED +
LED -
SW
（
Red/White
）
1
2
Align triangle on cable connector as shown.
