Installing hardware
About the installation process
It is strongly recommended that you review this chapter before you install the E-85A. Also keep in mind that installation
problems are easier to avoid and diagnose if you proceed from the component level to the system level, verifying
functionality at each step.
Since the E-85A is connected to the customer’s network, be sure to coordinate your installation schedule with the
administrator at the customer site. For information about network setup, refer the site administrator to
Configuration Guide
, which is part of the user documentation set.
If necessary, you can change the default language of the E-85A set at the factory (see
“To change the E-85A language”
Note:
You can change the default language that is preinstalled at the factory using the Configure tool available through
Command WorkStation and WebTools. Start Configure, choose Fiery Server > Regional Settings. From the Server
Language list, select your language and then click Save. When an Alert dialog box appears, click Continue. It takes up to
15 minutes to change languages.
You can also change the default language using the Fiery Quick Touch menu. Select Quick Launch > Settings, and log in to
the server as admin. From the language drop-down list, select the your language, save the changes, and then reboot the
server. It takes up to 15 minutes to complete the language changes.
To install the E-85A
1
Check installation requirements and verify site conditions.
If possible, obtain verification that the network is operational (see
).
2
Unpack the E-85A (see
3
If applicable, connect the monitor, keyboard, mouse, and furniture to the E-85A.
For more information on setting up the furniture, see the documentation that comes with the furniture kit.
4
Connect the following cables (see
•
Network cable (upper RJ-45)
•
Printer interface cable (lower RJ-45)
•
Network cable (lower RJ-45) to the PC Graphical User Interface
•
(Optional) USB cable with Type A and B connectors for power synchronization (see
)
5
(Optional) If the E-85A requires a static IP address (for example, in a non-DHCP network environment), work with the
site administrator to configure one.
