Edge-Core ECS4120-28F, Справочное руководство, Страница: 54 / 938

Chapter 1
| Initial Switch Configuration
Configuring the Switch for Remote Management
– 54 –
3.
Type “exit” to return to the global configuration mode prompt. Press <Enter>.
4.
To set the IP address of the IPv6 default gateway for the network to which the
switch belongs, type “ipv6 default-gateway
gateway ,” where “gateway” is the
IPv6 address of the default gateway. Press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ipv6 address 2001:DB8:2222:7272::/64
Console(config-if)#exit
Console(config)#ipv6 default-gateway 2001:DB8:2222:7272::254
Console(config)end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
fe80::260:3eff:fe11:6700%1/64
Global unicast address(es):
2001:db8:2222:7272::/64, subnet is 2001:db8:2222:7272::/64
Joined group address(es):
ff02::1:ff00:0
ff02::1:ff11:6700
ff02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#show ipv6 default-gateway
ipv6 default gateway: 2001:DB8:2222:7272::254
Console#
Dynamic Configuration
Obtaining an IPv4 Address
If you select the “bootp” or “dhcp” option, the system will immediately start
broadcasting service requests. IP will be enabled but will not function until a
BOOTP or DHCP reply has been received. Requests are broadcast every few minutes
using exponential backoff until IP configuration information is obtained from a
BOOTP or DHCP server. BOOTP and DHCP values can include the IP address, subnet
mask, and default gateway. If the DHCP/BOOTP server is slow to respond, you may
need to use the “ip dhcp restart client” command to re-start broadcasting service
requests.
Note that the “ip dhcp restart client” command can also be used to start
broadcasting service requests for all VLANs configured to obtain address
assignments through BOOTP or DHCP. It may be necessary to use this command
when DHCP is configured on a VLAN, and the member ports which were previously
shut down are now enabled.
If the “bootp” or “dhcp” option is saved to the startup-config file (step 6), then the
switch will start broadcasting service requests as soon as it is powered on.