Digimerge VB300 SERIES, Инструкция по эксплуатации

Страница: 107 / 142

97
Remote Setup
RS485
Configure options for a RS485 controller.
To configure RS485 options:
1. Use the drop-down menus to configure the
following options:
• SYSTEM ID : Set the system ID from 0~255.
Note: The system ID on the RS485
controller and the system must match in
order for the controller to function properly.
• BAUD RATE : Set the transmission rate for
the RS485 controller: 1200, 2400, 4800,
9600, 19200, 57600.
• DATA BIT
: Set the size of each bit of data
sent to the RS485 controller: 6, 7, or 8.
• PARITY BIT : Set the error checking for the
data to EVEN , ODD , or NONE .
• STOP BIT : Set bit for ending a transmission
to 1 or 2 .
2. To save your settings to your DVR, click
Update to DVR .
PTZ
Set the model, speed, and ID for connected
PTZ cameras (not included).
NOTE: Please refer to your PTZ camera’s
instruction manual prior to changing setting.
To configure PTZ options:
1. Under MODEL, select the following for the
channel(s) with a connected PTZ camera:
SPD , SRX-100B , VC-C4R , SD-290 ,
SCC-643 , PELCO P-TYPE/D-TYPE ,
DSC-230 , CS-854 , DMP23 , LPT-A100L ,
BOSCH , TK-C655 / C676 , SK-D106 , EZ ,
PCS-SERIES , PTZ-200C , KALATEL ,
VITEK , or NONE .
2. Under SPEED, select one of the following
for the channel(s) with a connected PTZ
camera:
1200 , 2400 , 4800 , 9600 , 19200 ,
57600 , and 115200 .
3. Under ID, click to set the PTZ ID from
0~255 .
4. To save your settings to your DVR, click
Update to DVR .
Figure 27.1 RS485 options
Figure 27.2 PTZ options