2-560
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show ipv6 access-list
show ipv6 access-list
Use the
show ipv6 access-list
user EXEC command to display the contents of all current IPv6 access
lists.
show ipv6 access-list
[
access-list-name
]
Note
This command is supported only if you have configured a dual IPv4 and IPv6 Switch Database
Management (SDM) template on the switch.
Syntax Description
Command Modes
User EXEC
Command History
Usage Guidelines
The
show ipv6 access-list
command provides output similar to the
show ip access-list
command, except
that it is IPv6-specific.
To configure the dual IPv4 and IPv6 template, enter the
sdm prefer
dual-ipv4-and-ipv6
{
default
|
vlan
)
global configuration command and reload the switch.
Examples
The following output from the
show ipv6 access-list
command shows IPv6 access lists named inbound
and outbound:
Switch#
show ipv6 access-list
IPv6 access list inbound
permit tcp any any eq bgp (8 matches) sequence 10
permit tcp any any eq telnet (15 matches) sequence 20
permit udp any any sequence 30
Table 2-29
describes the significant fields shown in the display.
access-list-name
(Optional) Name of access list.
Release
Modification
12.2(40)EX1
This command was introduced.
Table 2-29
show ipv6 access-list Field Descriptions
Field
Description
IPv6 access list inbound
Name of the IPv6 access list, for example, inbound.
permit
Permits any packet that matches the specified protocol type.
tcp
Transmission Control Protocol. The higher-level (Layer 4) protocol type
that the packet must match.
any
Equal to ::/0.
