B-11
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug ip dhcp snooping
debug ip dhcp snooping
Use the
debug ip dhcp snooping
privileged EXEC command to enable debugging of DHCP snooping.
Use the
no
form of this command to disable debugging.
debug ip dhcp snooping
{
mac-address
|
agent
|
event
|
packet
}
no debug ip dhcp snooping
{
mac-address
|
agent
|
event
|
packet
}
This command is supported only if your switch is running the IP services feature set.
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The
undebug ip dhcp snooping
command is the same as the
no debug ip dhcp snooping
command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the
session
switch-number
privileged EXEC command. Then enter the
debug
command at the command-line
prompt of the stack member. You also can use the
remote command
stack-member-number
LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
mac-address
Display debug messages for a DHCP packet with the specified MAC address.
agent
Display debug messages for DHCP snooping agents.
event
Display debug messages for DHCP snooping events.
packet
Display debug messages for DHCP snooping.
Release
Modification
12.2(40)EX1
This command was introduced.
Command
Description
show debugging
Displays information about the types of debugging that are
enabled.
