2-396
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
police aggregate
police aggregate
Use the
police aggregate
policy-map class configuration command on the switch stack or on a
standalone switch to apply an aggregate policer to multiple classes in the same policy map. A policer
defines a maximum permissible rate of transmission, a maximum burst size for transmissions, and an
action to take if either maximum is exceeded. Use the
no
form of this command to remove the specified
policer.
police aggregate
aggregate-policer-name
no police aggregate
aggregate-policer-name
Syntax Description
Defaults
No aggregate policers are defined.
Command Modes
Policy-map class configuration
Command History
Usage Guidelines
The port ASIC device, which controls more than one physical port, supports 256 policers on the switch
(255 user-configurable policers plus 1 policer reserved for internal use). The maximum number of
configurable policers supported per port is 63. Policers are allocated on demand by the software and are
constrained by the hardware and ASIC boundaries. You cannot reserve policers per port. There is no
guarantee that a port will be assigned to any policer.
You set aggregate policer parameters by using the
mls qos aggregate-policer
global configuration
command. You apply an aggregate policer to multiple classes in the same policy map; you cannot use an
aggregate policer across different policy maps.
To return to policy-map configuration mode, use the
exit
command. To return to privileged EXEC mode,
use the
end
command.
You cannot configure aggregate policers in hierarchical policy maps.
aggregate-policer-name
Name of the aggregate policer.
Release
Modification
12.2(40)EX1
This command was introduced.
