2-146
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
dot1x timeout
dot1x timeout
Use the
dot1x timeout
interface configuration command on the switch stack or on a standalone switch
to set IEEE 802.1x timers. Use the
no
form of this command to return to the default setting.
dot1x timeout
{
quiet-period
seconds
|
ratelimit-period
seconds
|
reauth-period
{
seconds
|
server
}
|
server-timeout
seconds
|
supp-timeout
seconds
|
tx-period
seconds
}
no dot1x timeout
{
quiet-period
|
reauth-period
|
server-timeout
|
supp-timeout
|
tx-period
}
Syntax Description
Defaults
These are the default settings:
reauth-period
is 3600 seconds.
quiet-period
is 60 seconds.
tx-period
is 5 seconds.
supp-timeout
is 30 seconds.
server-timeout
is 30 seconds.
rate-limit
is 1 second.
Command Modes
Interface configuration
Command History
quiet-period
seconds
Number of seconds that the switch remains in the quiet state following a
failed authentication exchange with the client. The range is 1 to 65535.
ratelimit-period
seconds
Number of seconds that the switch ignores Extensible Authentication
Protocol over LAN (EAPOL) packets from clients that have been
successfully authenticated during this duration. The range is 1 to 65535.
reauth-period
{
seconds
|
server
}
Set the number of seconds between re-authentication attempts.
The keywords have these meanings:
•
seconds
—Sets the number of seconds from 1 to 65535; the default is
3600 seconds.
•
server
—Sets the number of seconds as the value of the
Session-Timeout RADIUS attribute (Attribute[27]).
server-timeout
seconds
Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server. The range is 30 to 65535.
supp-timeout
seconds
Number of seconds that the switch waits for the retransmission of packets
by the switch to the IEEE 802.1x client. The range is 30 to 65535.
tx-period
seconds
Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the
request. The range is 1 to 65535.
Release
Modification
12.2(40)EX1
This command was introduced.
