2-577
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show lacp
Table 2-30
describes the fields in the display.
This is an example of output from the
show lacp internal
command:
Switch>
show lacp 1 internal
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode P - Device is in Passive mode
Channel group 1
LACP port Admin Oper Port Port
Port Flags State Priority Key Key Number State
Gi2/0/1 SA bndl 32768 0x3 0x3 0x4 0x3D
Gi2/0/2 SA bndl 32768 0x3 0x3 0x5 0x3D
Table 2-31
describes the fields in the display:
Table 2-30
show lacp counters Field Descriptions
Field
Description
LACPDUs Sent and Recv
The number of LACP packets sent and received by a port.
Marker Sent and Recv
The number of LACP marker packets sent and received by a port.
Marker Response Sent and Recv
The number of LACP marker response packets sent and received
by a port.
LACPDUs Pkts and Err
The number of unknown and illegal packets received by LACP
for a port.
Table 2-31
show lacp internal Field Descriptions
Field
Description
State
State of the specific port. These are the allowed values:
•
– —Port is in an unknown state.
•
bndl
—Port is attached to an aggregator and bundled with
other ports.
•
susp
—Port is in a suspended state; it is not attached to any
aggregator.
•
hot-sby
—Port is in a hot-standby state.
•
indiv
—Port is incapable of bundling with any other port.
•
indep
—Port is in an independent state (not bundled but able
to switch data traffic. In this case, LACP is not running on
the partner port).
•
down
—Port is down.
LACP Port Priority
Port priority setting. LACP uses the port priority to put ports s
in standby mode when there is a hardware limitation that
prevents all compatible ports from aggregating.
